Where can I find the correct pinmux settings for the PRU as well as which pru gpio port maps to which header bin? I don't see it on Derek Molloy's header table.
On Wednesday, October 2, 2013 8:03:29 PM UTC, Charles Steinkuehler wrote: > > On 9/30/2013 8:40 AM, [email protected] <javascript:> wrote: > > Is it possible to use these two PRU (pru0 and pru1) simultaneously to > > control fast GPIO in direct PRU - output mode? If yes, how can we do > that > > with only r30? > > Each PRU has it's own r30, which drives the direct outputs (assuming you > have the pinmux setup properly). You can only drive a limited number of > the BeagleBone header pins using PRU direct I/O, and a lot of the pins > are shared with the LCD/HDMI interface. > > -- > Charles Steinkuehler > [email protected] <javascript:> > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
