Ok, good to know! Thank you :) I do have a request (or, a suggestion) for the SRM though: In "Figure 55. Expansion Board EEPROM Write Protect", could you put the pull-up resistors on the I2C0_SCL and I2C0_SDA signals as they are in Figure 54? So that when idiots like myself do a direct copy into a schematic, they don't send the design off to the PCB house without them pulled up? Yes, I actually did this.. *bashes head on keyboard*
Dennis On Monday, January 27, 2014 8:59:15 AM UTC-5, Gerald wrote: > > All the SW uses is the name of the board and maybe the revision. None of > the other stuff ever got implemented. > > Gerald > > > > On Mon, Jan 27, 2014 at 7:57 AM, Dennis McLeod <[email protected]<javascript:> > > wrote: > >> Bits 15, and 6:0 are used by SW though, correct? It's just bits 14:13 >> you're saying aren't used by SW? >> >> On a related note, and forgive me if it's a silly question.. but does >> having the eeprom programmed with this table mean that it's not necessary >> to create a *.dtbo file? >> >> >> Thanks Gerald, >> >> Dennis >> >> >> >> On Monday, January 27, 2014 8:50:49 AM UTC-5, Gerald wrote: >> >>> Well, considering none of this is being used by the SW, take your pick >>> and I will change it to whatever you like. >>> >>> Gerald >>> >>> >>> >>> On Fri, Jan 24, 2014 at 5:25 PM, Dennis McLeod <[email protected]> wrote: >>> >>>> In the SRM in table 14, it says under "Pin Usage" that: >>>> >>>> Bit 15..............Pin is used or not..............0=Unused by cape >>>> 1=Used by cape >>>> Bit 14-13.........Pin Direction...................1 0=Output 01=Input >>>> 11=BDIR >>>> Bits 12-7.........Reserved........................should be all zeros >>>> >>>> but in the next section, 8.2.5, it says bits 14-7 are reserved. >>>> >>>> Which is correct? >>>> >>>> -- >>>> For more options, visit http://beagleboard.org/discuss >>>> --- >>>> You received this message because you are subscribed to the Google >>>> Groups "BeagleBoard" group. >>>> To unsubscribe from this group and stop receiving emails from it, send >>>> an email to [email protected]. >>>> >>>> For more options, visit https://groups.google.com/groups/opt_out. >>>> >>> >>> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> For more options, visit https://groups.google.com/groups/opt_out. >> > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
