On Saturday, February 1, 2014 2:58:14 AM UTC+5:30, Mahendra Gunawardena
wrote:
>
>
> I have successfully loaded TI-Android pre-built image on a BBB which was
> downloaded from
> here<http://downloads.ti.com/sitara_android/esd/TI_Android_DevKit/TI_Android_JB_4_2_2_DevKit_4_1_1/index_FDS.html>.
>
> Everything works well on the device. I have been trying to enable adb
> without much luck. Basic HW and SW is as follows
>
> *Hardware*
>
> - Beaglebone black.
> - 4DCAPE-43T.
> - 5V power supply.
> - mini usb connection to Ubuntu 12.04 LTS host system.
>
> *Software*
>
> - TI-Android JB image
> (TI_Android_JB_4.2.2_DevKit_4.1.1_beagleboneblack.tar.gz).
> - Ubuntu 12.04 LTS host system.
>
> On the BBB I have turned on USB debugging by
>
> - App Launcher" -> "Settings" -> "Developer options"
>
> This should have been enabled by default. Was this not the case?
> On the Host side
>
> lsusb output is
> Bus 001 Device 002: ID 8087:0024 Intel Corp. Integrated Rate Matching Hub
> Bus 002 Device 002: ID 8087:0024 Intel Corp. Integrated Rate Matching Hub
> Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
> Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
> Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
> Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
> Bus 001 Device 003: ID 0bda:0129 Realtek Semiconductor Corp.
> Bus 001 Device 004: ID 10f1:1a52 Importek
>
> */etc/udev/rules.d/51-android.rules*
>
> SUBSYSTEM=="usb", SYSFS{idVendor}=="18d1", MODE="0666"
> SUBSYSTEM=="usb", SYSFS{idVendor}=="0451", MODE="0666"
>
> I have executed the following two commands
> chmod a+r /etc/udev/rules.d/51-android.rules
> sudo service udev restart
>
>
> When I do an
> adb devices
>
>
>
> I don't see the BBB, but when I have HTC phone attached I do see a valid
> response.
>
>
> What I am doing wrong?
>
>
> Also I plug the mini-usb to the host machine. Is this correct?
>
Yes, you need to connect the mini-usb cable which came with BBB to access
adb.
Recheck the connections. You should get an entry for VID 18d1 once adbd is
up on BBB.
-Vishveshwar
> Or do I have connect to the serial debugging port.
>
> Thanks
>
>
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.
