As I mentioned, these were the procedures that were followed exactly. . The user button was depressed fully till all LEDs came ON and I guess that is also seen from the screen dump as it senses the status. The problem is that flashing does n't happen as in many other cases mentioned here. It should atleast boot from an SD card having the new image but even that does n't happen I guess... strange.
I find many had faced these types of issues with this version of board... it may be due to hardware, drivers. QC or any design issue.. don't know if all these similar issues reported here were fixed or boards replaced... anbu On Thursday, February 6, 2014 10:26:16 AM UTC-8, doog wrote: > > Since you tried flashing the eMMC and it's unknown where or what happened, > you probably should solve your problems there and get a valid/complete > flashing done so you know you have a starting place. I think the > instructions are here: http://beagleboard.org/Getting%20Started#update > > it's also a big deal how/when you hold down the button on the BBB. Once > that is done, then it would be time to figure out if you have a cable > problem, connector problem, or a Windows problem regarding the USB side. At > the very least your computer should be seeing some kind of USB device > connecting to it and given you used many different computers it could > possibly be a hardware issue. That is if the system wasn't currupted > somehow in failed attempts. > > Doug > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
