Hi, Gerald, I want 1600 x 900, how do I set the TDA19988 to accept this in 'DVI' mode only, no audio.
I don't want 1920x1080, I just pointed out that as an example :-) Thanks Nick On Sunday, 23 February 2014 10:00:11 UTC+8, Gerald wrote: > 1920x1080@24 works fine. @60, well, that is not possible. > > > Gerald > > > > On Sat, Feb 22, 2014 at 5:45 PM, Nick Smith > <[email protected]<javascript:> > > wrote: > >> Hi, >> 1. I cannot find any information on the 16:9 formatted >> displays for 1600:900 lcd displays. The datasheet for the HDMI controller >> chip TDA19988 >> is very allusive for some reason, got my hands on the TDA19983 data >> sheet though >> 2. I did my calculations 1600x900x60Hz =86.4 Mhz just over >> the edge as regards the 85Mhz for hdmi audio. But I don't need audio. I >> just want to >> drive the HDMI in "DVI' mode dropping the audio. There is a >> lot of chatter about theoretical possibility of 1920x1080 @ 60Hz, but >> no mention on how it's >> accomplished so I can use it as a guide >> >> >> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> For more options, visit https://groups.google.com/groups/opt_out. >> > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
