The framer does not set the resolution. It is all a function of the kernel and the DRM interface..
Gerald On Sun, Feb 23, 2014 at 9:43 PM, William Hermans <[email protected]> wrote: > Nick, > > To disable teh HDMI audio you would do that via uEnv.txt on the boot > partition. > > In the file you add . . > > optargs=capemgr.disable_partno=BB-BONELT-HDMIN > > This assumes you're using kernel version 3.8.x > > > On Sun, Feb 23, 2014 at 8:25 PM, Nick Smith <[email protected] > > wrote: > >> Hi, Gerald, >> >> I want 1600 x 900, how do I set the TDA19988 to accept this in 'DVI' >> mode only, no audio. >> >> >> I don't want 1920x1080, I just pointed out that as an example :-) >> >> Thanks >> >> Nick >> >> On Sunday, 23 February 2014 10:00:11 UTC+8, Gerald wrote: >> >>> 1920x1080@24 works fine. @60, well, that is not possible. >>> >> >> >> >>> >>> Gerald >>> >>> >>> >>> On Sat, Feb 22, 2014 at 5:45 PM, Nick Smith >>> <[email protected]>wrote: >>> >>>> Hi, >>>> 1. I cannot find any information on the 16:9 formatted >>>> displays for 1600:900 lcd displays. The datasheet for the HDMI controller >>>> chip TDA19988 >>>> is very allusive for some reason, got my hands on the TDA19983 data >>>> sheet though >>>> 2. I did my calculations 1600x900x60Hz =86.4 Mhz just over >>>> the edge as regards the 85Mhz for hdmi audio. But I don't need audio. I >>>> just want to >>>> drive the HDMI in "DVI' mode dropping the audio. There is a >>>> lot of chatter about theoretical possibility of 1920x1080 @ 60Hz, but >>>> no mention on how it's >>>> accomplished so I can use it as a guide >>>> >>>> >>>> >>>> -- >>>> For more options, visit http://beagleboard.org/discuss >>>> --- >>>> You received this message because you are subscribed to the Google >>>> Groups "BeagleBoard" group. >>>> To unsubscribe from this group and stop receiving emails from it, send >>>> an email to [email protected]. >>>> For more options, visit https://groups.google.com/groups/opt_out. >>>> >>> >>> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> For more options, visit https://groups.google.com/groups/opt_out. >> > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
