Yes, u-boot looks for uImage at first. When it doesn't find it it looks for zImage. You can see from the log that it's read the kernel and the FDT:
2692216 bytes read in 212 ms (12.1 MiB/s) 15670 bytes read in 45 ms (339.8 KiB/s) Booting with DT from mmc0 ... Kernel image @ 0x80200000 [ 0x000000 - 0x291478 ] Regards, Ralph On Monday, March 3, 2014 5:19:59 PM UTC-8, RobertCNelson wrote: > > On Mon, Mar 3, 2014 at 3:31 PM, rdbirt <[email protected] <javascript:>> > wrote: > > HiAll, > > > > I have built kernel version 3.13.5 for the Beagleboard-xM. At boot it > hangs > > at "Starting kernel ..." (see capture below). Has any one had success > with > > 3.13? > > > > Regards, > > Ralph > > > > > > U-Boot SPL (Feb 28 2014 - 11:58:43) > > reading u-boot.img > > reading u-boot.img > > > > > > U-Boot 2014.04-rc1-00190-geeb72e6 (Feb 28 2014 - 11:59:40) > > > > OMAP36XX/37XX-GP ES1.2, CPU-OPP2, L3-200MHz, Max CPU Clock 1 Ghz > > OMAP3 Beagle board + LPDDR/NAND > > I2C: ready > > DRAM: 512 MiB > > NAND: 0 MiB > > MMC: OMAP SD/MMC: 0 > > *** Warning - readenv() failed, using default environment > > > > In: serial > > Out: serial > > Err: serial > > Beagle xM Rev C > > Timed out in wait_for_event: status=0000 > > Check if pads/pull-ups of bus 1 are properly configured > > No EEPROM on expansion board > > Die ID #023200029ff80000016849a90301801c > > Net: usb_ether > > Hit any key to stop autoboot: 0 > > mmc0 is current device > > gpio: pin 173 (gpio 173) value is 0 > > gpio: pin 4 (gpio 4) value is 0 > > SD/MMC found on device 0 > > reading uEnv.txt > > 106 bytes read in 3 ms (34.2 KiB/s) > > Loaded environment from uEnv.txt > > Importing environment from mmc ... > > ** File not found /boot/uImage ** > > Booting from nand ... > > > > no devices available > > Wrong Image Format for bootm command > > ERROR: can't get kernel image! > > mainline u-boot is looking for "uImage" at /boot/. > > so fix that.. > > Or use the patches posted here: > > http://eewiki.net/display/linuxonarm/BeagleBoard > > Regards, > > -- > Robert Nelson > http://www.rcn-ee.com/ > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
