Hi Robert, Same thing at 0x80300000:
Booting with DT from mmc0 ... Kernel image @ 0x80300000 [ 0x000000 - 0x291478 ] ## Flattened Device Tree blob at 80f80000 Booting using the fdt blob at 0x80f80000 Using Device Tree in place at 80f80000, end 80f86d35 Starting kernel ... Has the serial port changed maybe? I added bootargs "console=ttyO2,115200n8 root=/dev/mmcblk0p2 rw rootfstype=ext4 rootwait" to the FDT. Regards, Ralph On Monday, March 3, 2014 1:31:29 PM UTC-8, rdbirt wrote: > > HiAll, > > I have built kernel version 3.13.5 for the Beagleboard-xM. At boot it > hangs at "Starting kernel ..." (see capture below). Has any one had > success with 3.13? > > Regards, > Ralph > > > U-Boot SPL (Feb 28 2014 - 11:58:43) > reading u-boot.img > reading u-boot.img > > > U-Boot 2014.04-rc1-00190-geeb72e6 (Feb 28 2014 - 11:59:40) > > OMAP36XX/37XX-GP ES1.2, CPU-OPP2, L3-200MHz, Max CPU Clock 1 Ghz > OMAP3 Beagle board + LPDDR/NAND > I2C: ready > DRAM: 512 MiB > NAND: 0 MiB > MMC: OMAP SD/MMC: 0 > *** Warning - readenv() failed, using default environment > > In: serial > Out: serial > Err: serial > Beagle xM Rev C > Timed out in wait_for_event: status=0000 > Check if pads/pull-ups of bus 1 are properly configured > No EEPROM on expansion board > Die ID #023200029ff80000016849a90301801c > Net: usb_ether > Hit any key to stop autoboot: 0 > mmc0 is current device > gpio: pin 173 (gpio 173) value is 0 > gpio: pin 4 (gpio 4) value is 0 > SD/MMC found on device 0 > reading uEnv.txt > 106 bytes read in 3 ms (34.2 KiB/s) > Loaded environment from uEnv.txt > Importing environment from mmc ... > ** File not found /boot/uImage ** > Booting from nand ... > > no devices available > Wrong Image Format for bootm command > ERROR: can't get kernel image! > 2692216 bytes read in 212 ms (12.1 MiB/s) > 15670 bytes read in 45 ms (339.8 KiB/s) > Booting with DT from mmc0 ... > Kernel image @ 0x80200000 [ 0x000000 - 0x291478 ] > ## Flattened Device Tree blob at 80f80000 > Booting using the fdt blob at 0x80f80000 > Using Device Tree in place at 80f80000, end 80f86d35 > > Starting kernel ... > > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
