On Fri, Jun 6, 2014 at 10:14 AM, Troy <[email protected]> wrote: > I just purchased a new Beaglebone Black RevC and I'm starting to experiment > a bit. I'm seeing some strange behavior when trying to perform a graceful > shutdown of the board. When connected through the micro USB shutdown works > as expected. When an external power supply is used, and I'm connected > through Ethernet, I can't get the board to shutdown properly. > > Following are my two experimental cases: > > Case 1 - Power through USB > > Start with all cables unplugged > Connect to laptop through micro USB > Lamp for 5V power turns on. > Beaglebone boots in about 30s > Push power button on Beaglebone > Beaglebone shuts down in about 6s > All LED's are off. > > Case 2 - External power > > Start with all cables unplugged > Apply external 5V power. > Lamp for 5V power turns on. > Beaglebone boots in about 30s > Push power button on Beaglebone > Nothing happens! > > In each case, I also tried connecting through an SSH session. In both cases, > pressing the power button is issuing a shutdown command. I also tried > explicitly issuing a shutdown command through the SSH session (i.e. shutdown > -h now). When powered through USB it works; when powered externally the > shutdown doesn't occur. > > Any ideas or suggestions?
odd.. What version of the image: cat /etc/dogtag Regards, -- Robert Nelson http://www.rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
