Hi, Thank you for your reply. You where correct and I got what was the problem. I will check with this.
On Tuesday, June 10, 2014 6:53:21 PM UTC+5:30, RobertCNelson wrote: > > > Hi, > > Thank you for the reply. > > > > I tried SSHing into beaglebone black, but it s not happening. > > > > The serial output is as follows: > > > > [ 0.000000] Kernel command line: console=ttyO0,115200n8 > root=/dev/sdb2 ro > > rootfstype=ext4 rootwait fixrtc > > > [ 2.506335] Waiting for root device /dev/sdb2... > > > [ 2.660973] mmc1: BKOPS_EN bit is not set > > [ 2.667609] mmc1: new high speed MMC card at address 0001 > > [ 2.673806] mmcblk1: mmc1:0001 MMC02G 1.78 GiB > > [ 2.678788] mmcblk1boot0: mmc1:0001 MMC02G partition 1 1.00 MiB > > [ 2.685184] mmcblk1boot1: mmc1:0001 MMC02G partition 2 1.00 MiB > > [ 2.693634] mmcblk1: p1 p2 > > [ 2.698420] mmcblk1boot1: unknown partition table > > [ 2.704927] mmcblk1boot0: unknown partition table > > > > What might be the reason for the above log? > > Is it the mistake with sd card partition? > > You told it to use "root=/dev/sdb2" however that device id doesn't > come up. It should be "root=/dev/mmcblk(x)p(y)" format. > > Regards, > > -- > Robert Nelson > http://www.rcn-ee.com/ > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
