Thanks guys. I've confirmed that the board was dead. Replaced it with a new board and life is good again. Also did give a quick read over the reference manual, which is quite helpful.
On Mon, Aug 18, 2014 at 10:41 AM, Gerald Coley <[email protected]> wrote: > http://www.elinux.org/Beagleboard:BeagleBoneBlack#Hardware_Files > > Look for the System Reference Manuel that is the same revision as your > board. > > Gerald > > > On Mon, Aug 18, 2014 at 9:30 AM, Tim Jones <[email protected]> > wrote: > >> Just make sure the usb cable will charge a cell phone or any other device >> to make sure you have power. >> >> Tim >> >> >> On Monday, August 18, 2014 1:15:01 AM UTC-5, Jeff Hughes wrote: >>> >>> Hey there. Pretty sure my BeagleBone Black is dead but it would be good >>> if someone could confirm. I got it in an OpenROV kit along with an arduino >>> board for controlling motors and other stuff. Everything worked fine for a >>> few days, but then the whole thing stopped responding. I hadn't really >>> looked closely at the BBB prior to this, so I don't know if any of the LEDs >>> on the board were lighting up when running but I would assume so. Anyway >>> to troubleshoot the problem I connected the BBB itself to a USB cable from >>> my computer which should power the board but... nothing. No LEDs come on. >>> Not even the power LED over by the 5V power supply connector (which I am >>> not using). >>> >>> Is there something else I should try? Any diagnostics I could run? Or >>> key points on the PCB where I should check voltage levels? I don't have the >>> 5V power supply so I'm sortof stuck with USB to power the card. >>> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> >> For more options, visit https://groups.google.com/d/optout. >> > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to a topic in the > Google Groups "BeagleBoard" group. > To unsubscribe from this topic, visit > https://groups.google.com/d/topic/beagleboard/25oVOMCd10M/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
