Hello, thanks a lot for that hint. Currently I connected the SYS_Reset Pin of the Beagle to the reset pin of the Atmega. This will disable all drivers until the BBB is up and running, right? Or is there any other thing I can do till the beagle is up?
Am Freitag, 19. September 2014 04:53:36 UTC+2 schrieb [email protected]: > > > > Hi Uli, > > on your design, some your signals go to the BBB boot mode pins. > For example, 2_D0_RX signal goes to the SYS_BOOT_8 of the BBB which must > be Low at power up. > Please check every other your signal likewise, if they do not prevent the > BBB from booting. > > Normally people just disable all the drivers on the cape until the BBB is > up and running. > This is what was initially suggested. > > >>> >>> -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
