On Wednesday, November 12, 2014 3:51:33 PM UTC-7, RobertCNelson wrote: > > What is the serial output look like, after flashing, after removing > the microsd and after removing power.. (sysboot pins need to drain) > > Then apply power.. > > What's the serial output at that point? >
I just tried again, and let the board sit without power for about 30 seconds. Plugging the power back in gives no serial output whatsoever. I've tried holding the power, reset, and boot buttons in various combinations that I didn't systematically document (but could, if needed), to no avail. The only thing that seems to matter is having the SD card in. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
