On Wed, Jan 14, 2015 at 1:51 PM, Robert Nelson <[email protected]> wrote: > > > On Wed, Jan 14, 2015 at 1:33 PM, M Hickman <[email protected]> wrote: >> >> Thank you, Robert. I appreciate you adding a ros-hydro config! >> >> I followed your instructions (under 14.04 on the Black). I dd'd the image >> to the SD card booted it. The flasher started and then halted with a kernel >> panic. I tried re-writing the image to the SD card using my Mac, with the >> same result. >> >> I looked through the forums for clues. I copied >> BBB-eMMC-flasher-ubuntu-14.04.1-console-armhf-2015-01-06-2gb.img to the SD >> card, booted it and it flashed the eMMC just fine, so it's not a faulty SD >> card. I am powering the board with a 5V supply that came with the board and >> have nothing else attached. Not sure where to go from here. >> >> My FTDI cable is at the office, so I've attached a photo of the HDMI >> output. The final lines before the kernel panic are: > > > No worries about the ftdi, everything is mirrored to the hdmi now. ;) > > >> >> >> ---------------- >> Formatting: /dev/mmcblk1 >> [ ] mmcblk1: unknown partition table >> [ ] mmcblk1: p1 >> mkfs.ext4 /dev/mmcblk1p1 -L BOOT >> [ ] Kernel panic - not syncing: Attempted to kill init! >> exitcode=0x00000100 >> >> Suggestions? > > > What's odd, it's failing so early. Does it always stop at the same place. > (you don't have to re0image the microSD card).. > > For clarification (and i'll test here) what was the file name of the flasher > that is failing?
ah this is after you did: ./RootStock-NG.sh -c ros_hydro Fires up my imx6q... probably something in 12.04 that's breaking things.. Regards, -- Robert Nelson http://www.rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
