Hello,
I am trying to use the beagleboard (revD) for some testing, but I find it real hard to use it. I have found some binaries which enable me to get to linux prompt, but on trying to compile u-boot and kernel myself it get into several failures when booting from SD card: 1. First I tried just to change the kernel (with the same u-boot binary - no change), I have compile the kernel with PSP 04.02.00.07: *make distclean* *make omap3beagle_defconfig* *make uImage* But the kernel fail to start as following: Starting kernel ... Uncompressing Linux... done, booting the kernel. Error: unrecognized/unsupported machine ID (r1 = 0x00000706). Available machine support: ID (hex) NAME 0000060a OMAP3 Beagle Board Please check your kernel config and/or bootloader. 2. next thing I tried to compile u-boot: *make distclean* *make omap3_beagle_config * *make* But Then the u-boot fail to start: Texas Instruments X-Loader 1.5.0 (Jun 14 2011 - 22:04:07) Beagle Rev C5 Reading boot sector Loading u-boot.bin from mmc U-Boot 2010.09 (Jul 21 2013 - 14:17:04) (And there are no more printing) I also get the same result with the pre-built binaries in the /beagle folder of the PSP. Is there something wrong with the above steps for booting from SD with beagleboard ? Did anyone succeeded in running compiled u-boot/kernel with PSP 04.02.00.07 ? Should I move to older releases ? Is it that the beagle is not the correct for use with beagleboard ? (maybe it is beaglebone ) I would appreciate any suggestion. Regards, Ran -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
