Hello,
I am using bmp085 sensor with uext connection with beaglebone black.
I have made change in device tree of BBB. I have made i2c1(pin 17 and 18)
as input pin and pulled up internally and set it to mode two. I have also
set compatible property in device tree to load module of bmp085.
After looking into hardware design manual of bmp085 I interface with
beaglebone black.I connected four wire (vdd(pin3),gnd(pin1),sda(pin17) and
scl(pin18)) and kept other unconnected.
https://www.olimex.com/Products/Modules/Sensors/MOD-BMP085/resources/MOD-BMP085_sch.pdf
When I boot my kernel my bmp085 module is loaded automatically and I am
getting entry in /dev of i2c1
Problem:
When I connect BBB with bmp085 my kernel hangs or BBB does not start at
all!!!!What may be the problem????
Note:
I am not using 5v supply.
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
