I suggest that you take a moment and reflash the eMMC.. Gerald
On Sat, Jan 31, 2015 at 2:49 PM, <[email protected]> wrote: > My BeagleBone Black has been running for a couple of weeks with the > 2014-05-14 Debian release on the eMMC. The other day I found it with the > power light on but no heartbeat. Power cycling did not result in a > successful reboot. I can boot it up just fine from the SD card but the SD > card is /dev/mmcblk0 and there is no /dev/mmcblk1. If I boot with the > flasher version of debian on the SD card it boots but then begins a double > quick flash of all four leds which I assume means it couldn't find the eMMC > chip. > > Any way to reset or troubleshoot the eMMC chip? Or should I just assume > it's dead and always use the DC card? > > The only device that has been attached has been a BMP180 > pressure/temperature sensor running at 3.3v and connected via the I2C bus. > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- Gerald [email protected] http://beagleboard.org/ http://circuitco.com/support/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
