On 20 May 2015 at 13:55, Maximiliano O. Sonnaillon <[email protected]> wrote:
> I will probably have to add an extra buffer to have PGOOD in 3.3V level Heh, it's a pity U3 is an inverter rather than a buffer... it's currently not actually used (hardware reset is not enabled in eMMC), it's located at the top of the PCB (where you can also find PGOOD) while its output is available via R162 on the bottom of the PCB (where you'd need the enable signal for the regulator), and since its existing input and output connect to pins which are high-Z/don't-care by default you wouldn't even need to disconnect those. But there's no useful inverted signal available to use as enable afaict... -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
