How many amps are the PSUs your using? On Jun 3, 2015 7:16 PM, <[email protected]> wrote:
> Just got my brand new kit and got it up, updated to the latest Debian 7.8 > everything seemed to run fine, the Ethernet connection works good. Now came > the time to see if I could boot the board on my new 5V power supply. That > didn't go well. The leds came on, then off then on then off every 30 > seconds or so. > > I hooked up my serial cable, started a tty terminal to see if anything was > coming up and behold, the board seemed to be stuck in a boot loop. I > observed it go through the boot sequence, bring up the OS and then when the > login prompt comes up, the board reboots all over again. Tried different > power supplies, all with the same result. I went to the IRC channel to get > some help and was told I should try the new debian 8.0 release. I did so > with the same results. > > I cannot get this board to come up any other way than to connect the micro > usb cable to my pc. The power supply connection does not seem to work and > I don't understand what the difference between the two might be. > > There is something very flaky going on somewhere and I am out of ideas > except to return the board for a new one. > > Has anyone encountered this issue before? Any opinions? > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
