Second thought, I may just pull in a 4.1.x image and go with that. If you have one that does not reboot that often . . . dahm board already auto booted . . .
Unless you want me to check this one out just for informational purposes. On Thu, Aug 6, 2015 at 6:04 PM, William Hermans <[email protected]> wrote: > By "older" I mean something in the range of 4.1.x lol I have found they're > much faster than the older image I was currently working with. *bone47 > > On Thu, Aug 6, 2015 at 6:03 PM, William Hermans <[email protected]> wrote: > >> *is it showing up under:* >>> >>> * sudo ifconfig -a ??* >>> >> >> No. >> >> *i've been mostly testing on the v4.1.x-ti branch, so something might* >>> * have broke on mainline..* >>> >>> * Do the other 2 serial ports show up?* >>> >>> * dmesg | grep serial* >>> >> >> william@xanbustester:~$ dmesg |grep serial >> [ 2.803479] 44e09000.serial: ttyS0 at MMIO 0x44e09000 (irq = 154, >> base_baud = 3000000) is a 8250 >> >> Robert, Give me a bit to make sure this is not my fault. >> >> First - >> >> william@xanbustester:~$ dtc -v >> Version: DTC 1.4.0 >> >> So this is the wrong version. Had to hack together /opt/scripts from an >> older wheezy 7.8 image, but I've got it in place now. About to start over >> from installing dtc. >> >> Also, I installed canutils *before* putting this image on the board in >> question. I kind of doubt that is the problem, but not discounting that >> possibility. >> >> So yeah give me a little bit to poke around, and if it's not going to >> work . . .feel free to recommend me an "older" more suitable image. It'll >> be a slight hassle to go into uEnv.txt to make changes, and run depmod, but >> honestly thats all pretty easy . . . It will be harder to slim down the >> image again and uh . . . other stuff. >> >> On Thu, Aug 6, 2015 at 5:40 PM, Robert Nelson <[email protected]> >> wrote: >> >>> On Thu, Aug 6, 2015 at 7:38 PM, William Hermans <[email protected]> >>> wrote: >>> > Anyway, yeah, not working. >>> >>> is it showing up under: >>> >>> sudo ifconfig -a ?? >>> >>> i've been mostly testing on the v4.1.x-ti branch, so something might >>> have broke on mainline.. >>> >>> Do the other 2 serial ports show up? >>> >>> dmesg | grep serial >>> >>> Regards, >>> >>> -- >>> Robert Nelson >>> https://rcn-ee.com/ >>> >>> -- >>> For more options, visit http://beagleboard.org/discuss >>> --- >>> You received this message because you are subscribed to the Google >>> Groups "BeagleBoard" group. >>> To unsubscribe from this group and stop receiving emails from it, send >>> an email to [email protected]. >>> For more options, visit https://groups.google.com/d/optout. >>> >> >> > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
