Full power cycle is required as documented, by just pressing the reset pin it'll use the previous boot device. Which you removed.. On Sep 18, 2015 11:32 PM, "Rick Mann" <[email protected]> wrote:
> This is the transcript of the boot and flash and halt. If I remove the SD > card at this point and press the reset button, I just get CCCCCC... > > http://pastebin.com/GXufknPT > > I see "bad magic", but it seems to proceed on to running the flasher. It > formats the eMMC and reboots, then I see this: > > [ 132.166661] systemd[1]: systemd-modules-load.service: main process > exited, code=exited, status=1/FAILURE > [FAILED] Failed to start Load Kernel Modules. > > Then it continues for a couple more minutes, and eventually shuts down. > Not sure what's causing the problem (don't know enough about Linux to > interpret what I see). > > Help would be much appreciated, thank you. > > -- > Rick Mann > [email protected] > > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
