Many Thanks Gerald, I got response to my RMA request this time. In fact I received response to all my earlier RMA request as well.
Cheers Mahesh On Tuesday, October 27, 2015 at 7:37:52 PM UTC+5:30, Gerald wrote: > > Try the RMA again. > > Gerald > > > On Tue, Oct 27, 2015 at 6:51 AM, mahesh ingle <[email protected] > <javascript:>> wrote: > >> Hi, >> >> I Also have exactly same behavior with my Rev C BBB. >> >> @Gerald: I tried RMA twice but i did not got any response !! I got the >> Board from Sumeet Online shop which is listed on beagleboard.org for >> Indian buyers. Any thoughts? >> >> >> Thanks & Regards >> Mahesh >> >> >> On Wednesday, November 5, 2014 at 2:29:00 AM UTC+5:30, Shu Liu wrote: >>> >>> Hi, >>> >>> There should be a short on board. The U2 shuts itself down to prevent >>> the high current draw which is caused by the short. That is why the LED >>> goes off after it blinks once. >>> >>> Regards, >>> Shu >>> >>> On Monday, October 27, 2014 10:56:34 PM UTC-5, [email protected] wrote: >>>> >>>> I am in the same situation. Was trying out new images. Did an forced >>>> SD change to a non-bootable bbb. Now it won't boot. Just a pwr blink then >>>> dead. >>>> >>>> Are there any other ways to recover other than RMA? PMIC replacement >>>> or reflashing of bootloader? >>>> >>>> Sam >>>> >>>> On Wednesday, June 18, 2014 9:53:25 PM UTC+8, Gerald wrote: >>>>> >>>>> Request an RMA. >>>>> >>>>> http://beagleboard.org/Support/RMA >>>>> >>>>> And read this. >>>>> http://www.elinux.org/Beagleboard:BeagleBoneBlack#Hardware >>>>> >>>>> Gerald >>>>> >>>>> >>>>> On Mon, Jun 9, 2014 at 5:54 PM, <[email protected]> wrote: >>>>> >>>>>> My BBB (A5A) was working fine with ARM Arch (installed on the eMMC), >>>>>> but since yesterday it won't turn on. I don't know what changed. >>>>>> >>>>>> When I plug the power source or the USB cable the PWR Led quickly >>>>>> blinks, but the board doesn't turn on. >>>>>> If I press the POWER button, the PWR led does a single blink too, but >>>>>> it doesn't proceed to boot. >>>>>> >>>>>> I also tried to boot from the SD card, but It didn't work. >>>>>> >>>>>> -- >>>>>> For more options, visit http://beagleboard.org/discuss >>>>>> --- >>>>>> You received this message because you are subscribed to the Google >>>>>> Groups "BeagleBoard" group. >>>>>> To unsubscribe from this group and stop receiving emails from it, >>>>>> send an email to [email protected]. >>>>>> For more options, visit https://groups.google.com/d/optout. >>>>>> >>>>> >>>>> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> For more options, visit https://groups.google.com/d/optout. >> > > > > -- > Gerald > > [email protected] <javascript:> > http://beagleboard.org/ > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
