Hi, I'm try to optimize boot time BeagleBone Black board. The forum
already has a few helpful tips to reduce boot time in stage u-boot and
linux kernel loading. But one question remains uncovered.
I found that there is a delay (near 2 sec) between the power on and the
emergance of first debug message on serial port. I wonder what's going on
in those two seconds. Is it CPU initialization procedure, or the way to
avoid jitter when plug in power supply. Is it possible to reduce this delay?
~[00:000] - plug in power supply
[*02:291*] ▒ *<------- Look here* [02:310] U-Boot SPL 2015.10-dirty (Nov 14
2015 - 13:18:58) [02:490] MMC: block number 0x100 exceeds max(0x0) [02:494]
MMC: block number 0x200 exceeds max(0x0) [02:498] *** Error - No Valid
Environment Area found [02:503] *** Warning - bad CRC, using default
environment [02:519] [02:551] [02:551] U-Boot 2015.10-dirty (Nov 14 2015 -
13:18:58 -0800) [02:555] [02:555] Watchdog enabled [02:559] I2C: ready
[02:613] DRAM: 512 MiB [02:661] Reset Source: Power-on reset has occurred.
[02:665] MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 [03:112] *** Warning - bad
CRC, using default environment [03:132] [03:207] Net: <ethaddr> not set.
Validating first E-fuse MAC [03:249] cpsw [03:250] Hit any key to stop
autoboot: 0 (autoboot.c) [03:255] gpio: pin 53 (gpio 53) value is 1
[03:330] switch to partitions #0, OK [03:332] mmc0 is current device
Regards.
- Andrey Kuznetcov
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to beagleboard+unsubscr...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
