On 17 February 2016 at 13:48, Taceant Omnes <[email protected]> wrote:
The main reason why I need spacers is because the FTDI cable that I connect to UART0 for debug purposes needs it. I have not checked if there is another FTDI cable that would fit. The cable I am using was bought by a colleague for purposes other than BBB development. If the BBB had a right-angle connector (such as in the link below) then a spacer might not be needed, however I am not sure if that would not cause other problems such as electrical noise or issues with EMC compliance. That may be the reason why a straight up connector is fitted in the BBB. http://www.mouser.co.uk/ProductDetail/Molex/22-28-8063/?qs=sGAEpiMZZMs%252bGHln7q6pmxD%2f5kNJnZVedr5Qq69vbIk=&_cdc=3 -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
