I think I know what is going on, I think the BBBW uses a bit more power than the BBB, I believe the power supply that came with my 3d printer may either be faulty or at it's limit of what it can supply. Going to look into a slightly beefier supply.
On Monday, December 19, 2016 at 3:42:01 PM UTC-5, William Hermans wrote: > > Well I do not have a BBBW, but I do have an rPI 3. Disabling power save at > boot is fairly easy. > > william@rpi:~$ sudo nano /etc/rc.local > Add: /sbin/iw dev wlan0 set power_save off > > william@rpi:~$ sudo reboot > william@rpi:~$ iwconfig wlan0 > wlan0 IEEE 802.11bgn Mode:Master Tx-Power=31 dBm > Retry short limit:7 RTS thr:off Fragment thr:off > Power Management:off > > However, I have a sneaking suspicion that this, and all the other methods > mentioned above won't work. I'm fairly sure Robert is using some form of a > network manager to handle the BBBW's wireless, and in this case, disabling > power_save will have to be done through this network manager. > > > > On Mon, Dec 19, 2016 at 10:52 AM, Jay Doobie <[email protected] > <javascript:>> wrote: > >> At this point I don't know what it is. I setup a cronjob to turn off >> wireless power management, but something else seems to be causing a crash. >> My SSH hangs or so so slow that I can type "ls" and walk away to make a cup >> of coffee and it still hasn't done an 'ls', but 5 minutes later, bam, it >> happens. >> >> I've looked in dmesg and journalctl to see if there are any messages, but >> nothing. >> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> To view this discussion on the web visit >> https://groups.google.com/d/msgid/beagleboard/2c23a6b8-df50-4a95-a43d-fbd9499724c0%40googlegroups.com >> >> <https://groups.google.com/d/msgid/beagleboard/2c23a6b8-df50-4a95-a43d-fbd9499724c0%40googlegroups.com?utm_medium=email&utm_source=footer> >> . >> >> For more options, visit https://groups.google.com/d/optout. >> > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/1a0cb60b-64ac-4cbf-b677-6999df34da78%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
