That link is for different dts files which I have seen before. So if I took one of them and compiled it to a dtbo file which is the correct way to enable it?
I have seen it done 2 ways: 1) Through the uEvt.txt file 2) Using the echo command to write to the slots file Both were done with using older debian builds and I could never get it to work. I am running Kernal 4.4.30 so based on your post that should be ok correct? On Sunday, April 30, 2017 at 8:57:45 PM UTC-5, RobertCNelson wrote: > > With v4.4.x+ kernels: > > > https://github.com/beagleboard/bb.org-overlays/commit/a20c3a6c8e4ee6760238d52a9d919b4df8aa7436 > > Regards, > > On Sun, Apr 30, 2017 at 8:08 PM, David Faulkner <[email protected] > <javascript:>> wrote: > >> Specs: >> >> Beaglebone Black Rev C >> Image Build 8.6 Jessie Debian >> LCD- Apollo Display G104X1-L03 >> >> >> >> So I am using the Beaglebone black and pairing it with a LVDS display. I >> layed out an interface board and hooked it up and at first it did not work >> unless I hooked up an HDMI >> interface. So I went into the uEnv.txt and unconmenteded the >> cmdline=coherent_pool=1M quiet cape_Universal=enable video=HDMI- A-1 >> 1024x768@60e >> and now it runs on its own. However the I have the board configured for >> 24 bit mode so the red and blue colors are swapped (See Picture below) >> >> >> >> I was aware that when the am335 swaps red and blue in 24 bit mode so it >> makes sense as the default BSP is configured for 16. >> But now I am struggling to enable 24 bit mode for the latest Jessie >> build. >> For the early Angstrom images all you had to do was go into the >> X11/xorg.conf and change the color depth from 16 to 24 and it worked. >> >> But for jessie if I do that it does the following on bootup: >> >> >> I am assuming this is conflict with TI's tilcdc driver but Im not sure. >> >> In any case what is the best way to enable 24 bits outside of the X11 >> config? >> >> Thanks >> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> To view this discussion on the web visit >> https://groups.google.com/d/msgid/beagleboard/b81d8dc1-2a64-4c67-b228-92722e2614f6%40googlegroups.com >> >> <https://groups.google.com/d/msgid/beagleboard/b81d8dc1-2a64-4c67-b228-92722e2614f6%40googlegroups.com?utm_medium=email&utm_source=footer> >> . >> For more options, visit https://groups.google.com/d/optout. >> > > > > -- > Robert Nelson > https://rcn-ee.com/ > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/0442418d-075c-475a-8e8b-cb391da08684%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
