The "TPS65217C PMIC" supports 1-cell LiPo battery (3.7V) only.
It might have damaged the PMIC IC.

http://www.ti.com/product/TPS65217

Regards,
Santosh

On Saturday, 6 January 2018 04:26:02 UTC+5:30, [email protected] wrote:
>
> The board will not boot from the LiPo Battery. When I plug in the battery 
> no LEDs turn on.
>
>
> I’m using a 1.6Ah / 7.4volt 2Cell Lipo battery. The battery shows 8.4 
> volts with a voltmeter.
>
>
> Pressing the Power Button or the Reset Button does nothing. If I plugin a 
> 12-volt power source into the barrel jack it will boot.
>
>
> Once booted the Battery Charging LED will blink. The four battery status 
> LEDs will turn on and off in sequence for several seconds. 
>
> Then they turn on solid for several seconds. It will continue this cycle 
> as long as no power is applied to the motor drivers. 
>
> The 25% LED is always red and the other three are always green.
>
>
> If I run rc_battery_check I see:
>
> Pack: 8.48V   Cell: 4.24V   DC Jack: 12.29V
>
>
> If I run rc_test_motors -d 1.0. I can run a motor from any of the motor 
> drivers. The Battery Charging LED will turn on solid while a motor
>
>  is running and will go back to blinking when the motor is disconnected. 
> The four battery status LEDs will turn off if a motor is running.
>
>
> I have not found any documentation on the battery status LEDs, so I do 
> not know what the LED's are telling me.
>
>
> I left the 12-volt power source and LiPo battery plugged in over night to 
> ensure the battery was fully charged. But it did not help.
>
>
> Am I missing something? Any ideas what is going on?
>
>
> Thanks,
>
> Keith
>

-- 
For more options, visit http://beagleboard.org/discuss
--- 
You received this message because you are subscribed to the Google Groups 
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To view this discussion on the web visit 
https://groups.google.com/d/msgid/beagleboard/b9a72749-59ab-4848-b91d-dc01927ba9b3%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

Reply via email to