you may try first start jconsole by open-x11 ~/j701/bin/jconsole and inside jconsole, start gtkide manually and see if any error messages. load 'gktide'
Птн, 07 Янв 2011, Brian Schott писал(а): > This long thread is almost 1 month dormant. You may remember that Bill > Lam helped me a lot to get jgtk to launch on my PowerPC Mac using > Tiger OSX 10.4.x using X11's gtk. Well, soon after that and after > exercising jgtk only a little I had problems where my Mac turned > itself off soon after awakening from sleep. So I replaced the PRAM > battery on my Mac after some puzzlement to figure out that the battery > was the problem. > > Then I got the Mac working again and relaunched jgtk successfully, but > the problem with the Mac shutting down reappeared! So I said to > myself, "I fixed the wrong thing, I'll get back to this problem after > the holidays, maybe." > > Then later when I started to investigate the problem further I thought > before I reported the problem to this forum, I would experiment to see > if the problem was X11 itself, and not jgtk, so I launched X11 alone. > There was no shutdown problem. So I next decided to test jgtk one more > time before making this report, but jgtk would no longer start (I > thought that it would not, but it might have been "hiding" as I > describe later). > > When working with Bill earlier, I had been using the following command > in my "terminal" application which is the unix console. > > open-x11 ~/j701/bin/jgtk.command > > Well, X11 opened and displayed its console, but not JGTK. So I typed > the following command directly into the X11 console. > > % ~/j701/bin/jgtk.command > |control error: script > | 3 :0'' > |[-7] /Users/brian/j701/addons/gui/gtk/gtk.ijs > i. 6 > 0 1 2 3 4 5 > > The good news is that jgtk seems to be hiding there somewhere, but > without the nice ide window. Now I am going to sleep my Mac and I'll > be back in a short while... > > ... Ok, I'm back. So far so good: the Mac has not shut down. So maybe > the problem occurs later in the jgtk, when the IDE window properly > opens. But I am not equipped t diagnose the j error message and I > would understand if Bill and everyone else does not want to get > involved to diagnose the error. But there I am. > > Thanks for reading this saga. > > On Wed, Dec 8, 2010 at 1:43 AM, bill lam <[email protected]> wrote: > > congratulations \o/ \o/ \o/ > > > ---------------------------------------------------------------------- > For information about J forums see http://www.jsoftware.com/forums.htm -- regards, ==================================================== GPG key 1024D/4434BAB3 2008-08-24 gpg --keyserver subkeys.pgp.net --recv-keys 4434BAB3 ---------------------------------------------------------------------- For information about J forums see http://www.jsoftware.com/forums.htm
