I'll answer my own question. But first a big thank-you to Robin Bowes! My SBR arrived today. I figured at worst, I'd send it back if things did not work without a controller. But I connected it to my router and used Net-UDAP to set it up to work wirelessly! There was some problem connecting to the wireless network the first couple of times that I tried. Perhaps I forgot a save_data or reset, or didn't set all the parameters.
Per the instructions, from factory reset I did discover conf 1 set interface=1 save_data reset --waited for blue and then discover conf 1 set squeezecenter_address=<squeeze center ip e.g., 192.168.0.8> set wireless_SSID=<name of your wireless network> set wireless_channel=11 <- I got this from router config set wireless_wpa_psk=<wpa passwd> set wireless_wpa_on=1 set interface=0 save_data reset <-- Not sure if I did this. Then my SBR showed the following setting bridging: 0 hostname: Squeezebox interface: 0 lan_gateway: 192.168.0.1 lan_ip_mode: 1 lan_network_address: 192.168.0.9 lan_subnet_mask: 255.255.255.0 primary_dns: 192.168.0.1 secondary_dns: 0.0.0.0 server_address: 0.0.0.0 squeezecenter_address: 192.168.0.8 BH �ueezecenter_name: localhost �@��� wireless_SSID: <network name> wireless_channel: 11 wireless_keylen: 0 wireless_mode: 0 wireless_region_id: 4 wireless_wep_key_0: wireless_wep_key_1: wireless_wep_key_2: wireless_wep_key_3: wireless_wep_on: 0 wireless_wpa_cipher: 3 wireless_wpa_mode: 1 wireless_wpa_on: 1 wireless_wpa_psk: <password> I disconnected from the SBR from the router. Powered off the SBR. Powered back on (in another room). SBR connected to the wireless network and shows up in SC. So far so good! mkt;303680 Wrote: > I have similar questions and a similar situation except my SB3 is > wireless and I would like to set up a SBR (without SBC) to work > wirelessly. > > Is it possible to connect the SBR with ethernet, use Net-UDAP to set > parameters and then use the SBR wirelessly? -- mkt ------------------------------------------------------------------------ mkt's Profile: http://forums.slimdevices.com/member.php?userid=14921 View this thread: http://forums.slimdevices.com/showthread.php?t=43722 _______________________________________________ beta mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/beta
