Hi, Using command '#birdc configure soft' from linux command line should not reset any peers.
Thank you Budiwijaya On Fri, 7 Apr 2023 at 01:03, <[email protected]> wrote: > Dear Forum, > I am new in bird. I am getting a problem. When I am doing "service bird > restart or reload" or "bird > configure" to affect any bgp config change, > add, modification etc., then bgp neighborships are being reset. Is there > any way to affect any configure change in bird.conf without resetting bgp > neighborships? > > Regards // Saifullah > > ----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- > > *The content of this email is confidential and intended for the recipient > specified in message only. It is strictly forbidden to share any part of > this message with any third party, without a written consent of the sender. > If you received this message by mistake, please reply to this message and > follow with its deletion, so that we can ensure such a mistake does not > occur in the future. * > ----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- > > > *House # 7/B, Road # 13, Gulshan-1, Dhaka-1212, Phone: +880 2 8814615-6, > 8814868 Email: [email protected] <[email protected]>, Website: > https://www.fiberathome.net/ <https://www.fiberathome.net/>* >
