On 28 Nov 2014, at 15:32, Jon Stovell wrote:
However, you can also configure QS to rescan whenever certain events
happen.
Good suggestion, Jon.
Note that you can also limit the trigger so it only runs when a specific
volume is mounted, and you can limit the rescan to it only checks that
volume instead of everything (by making the trigger do “XYZ (Catalog)
⇥ Rescan Catalog Entry”). You’ll need to enable the “Quicksilver
Catalog Entries” preset under Preferences → Catalog → Quicksilver.
You might want to make a trigger for when the volume is unmounted too,
so the missing files will get cleaned out immediately.
--
Rob McBroom
http://www.skurfer.com/
--
You received this message because you are subscribed to the Google Groups
"Quicksilver" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To post to this group, send email to [email protected].
Visit this group at http://groups.google.com/group/blacktree-quicksilver.
For more options, visit https://groups.google.com/d/optout.
