It was, don't recall exactly, but it was less then zero. Michael _____
From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Dale Leavens Sent: Tuesday, January 15, 2008 17:20 To: [email protected] Subject: Re: [BlindHandyMan] New toy Try neutral to ground. That should be 0 or more likely very low voltage. Dale Leavens, Cochrane Ontario Canada [EMAIL PROTECTED] <mailto:DLeavens%40puc.net> net Skype DaleLeavens Come and meet Aurora, Nakita and Nanook at our polar bear habitat. ----- Original Message ----- From: Michael Baldwin To: blindhandyman@ <mailto:blindhandyman%40yahoogroups.com> yahoogroups.com Sent: Tuesday, January 15, 2008 6:03 PM Subject: RE: [BlindHandyMan] New toy I went and tested a few, just to get the hang of it. hot to neutral was 117-119, and hot to ground was 122. Will be a little guessing work on my part, but I don't have to wait for eyes now when i do more wiring. Michael _____ From: blindhandyman@ <mailto:blindhandyman%40yahoogroups.com> yahoogroups.com [mailto:blindhandyman@ <mailto:blindhandyman%40yahoogroups.com> yahoogroups.com] On Behalf Of Dale Leavens Sent: Tuesday, January 15, 2008 16:55 To: blindhandyman@ <mailto:blindhandyman%40yahoogroups.com> yahoogroups.com Subject: Re: [BlindHandyMan] New toy Hi, Ron has explained it well, I would just like to point out that you probably won't get an exact 120 Volts, I have seen it as low as a hundred and as high as 135. Similarly, though ground should be at the same potential as the white neutral, there can actually be quite a difference, 30 volts. Hot to ground though won't ever be that low. It is too bad that no one makes an audible polarity tester for outlets. Dale Leavens, Cochrane Ontario Canada [EMAIL PROTECTED] <mailto:DLeavens%40puc.net> net Skype DaleLeavens Come and meet Aurora, Nakita and Nanook at our polar bear habitat. ----- Original Message ----- From: Michael Baldwin To: blindhandyman@ <mailto:blindhandyman%40yahoogroups.com> yahoogroups.com Sent: Tuesday, January 15, 2008 12:05 PM Subject: [BlindHandyMan] New toy Hi, In the mail today, i got my talking multimeter. Now what to do with the darn thing. i mainly got it to test the heating mats I am putting under my tile. if I don't test them at several points during the install, the warranty is void. How would I test an outlet to make sure I got the hot on the right screw? i am sure I will think of many many uses for it. Michael [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed]
