I have often enough just gripped a hacksaw blade in a rag or something enough to give comfort, could use a good glove I suppose usually with the teeth pointing toward me so it cuts on the pull stroke. You might need to grip the nut or the end of the bolt with channel grips or some other "womans' " tool to keep it from spinning at the teeth engage.
----- Original Message ----- From: Bob Kennedy To: [email protected] Sent: Tuesday, June 24, 2008 9:44 PM Subject: Re: [BlindHandyMan] the nut with a bolt problems You can get them at any hardware store. They are basically a plastic frame with a set screw or large thumb wheel that pinches the blade in place. You hold one end and the blade can stick out from very short to fairly long. The neat feature is it's just like a little saw where the blade is sticking out and there is no frame to get in the way. I don't recommend it for cutting heavy steel or large hardened bolts. But I've used mine on the tank screws and it works great. ----- Original Message ----- From: rs_denis To: [email protected] Sent: Tuesday, June 24, 2008 9:03 AM Subject: Re: [BlindHandyMan] the nut with a bolt problems Bob, I've never heard of the mini-hax saw. I'll add this to the list of things I have to check out. I knew the washers would have to be replaced as it was their deterioration that led to this problem in the first place. Ron Denis ----- Original Message ----- From: Bob Kennedy To: [email protected] Sent: Monday, June 23, 2008 9:32 PM Subject: Re: [BlindHandyMan] the nut with a bolt problems I've run across your problem many times before. Keep in mind the washers are rubber. Spraying them with petroleum based sprays will mean you have to replace them anyway. My cure for this is to get one of those "mini hack saws." You can adjust the length of blade that sticks out and there is no frame to bang on anything. A good coarse blade will cut right through the screws in a fairly short time. You may have to hold the screws from the under side to keep them from turning. Fortunately these aren't hardened bolts and they will give up with a minimum of cussing and carrying on. When you put the new screws in consider picking up a small can of silicone grease. You can coat the threads and both sides of the rubber washer to help with future leaks and corrosion of the screws. ----- Original Message ----- From: rs_denis To: [email protected] Sent: Monday, June 23, 2008 9:01 PM Subject: Re: [BlindHandyMan] the nut with a bolt problems John, the liquid wrench I tried after the WD40 is a kind of penetrating oil isn't it? Anyway, hope to acquire some PB-blaster and at Rob's advice some Bowl Works and we'll see how far that gets us. I suspect after that, I'll have to resort to the plumber because I'll run out of extra storage space for the chemicals <grin.> Ron Denis [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] __________ NOD32 3212 (20080624) Information __________ This message was checked by NOD32 antivirus system. http://www.eset.com [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] ------------------------------------------------------------------------------ No virus found in this incoming message. Checked by AVG. Version: 7.5.524 / Virus Database: 270.4.1/1516 - Release Date: 6/24/2008 7:53 AM [Non-text portions of this message have been removed]
