We arrange a drainage system like this around the outside of the footings of 
our basements to carry any water which percolates down the outside of the 
basement walls usually into storm drains or under the footing and into a sump 
in the basement where a pump is installed to pump the water up and away. It is 
often used around the footings of slab construction too. You should also do 
what you can to grade the surface ground away from the building.

If the drain is a foot and a half or more below where traffic is driving it 
should not be crushed.

You might do as well just to excavate along the outside edge of the building a 
little below the level of the floor and lay the weeping tile in the bottom of 
the trench with a slope then backfill with clean gravel and, depending on the 
elevations, the end of the tile can be just left to dribble out onto the 
ground. make sure too that your eaves troughs aren't adding to the water load.

It is a little difficult without really thoroughly understanding the ground but 
the principle is certainly sound.




  ----- Original Message ----- 
  From: Kevin Doucet 
  To: [email protected] 
  Sent: Tuesday, August 26, 2008 7:50 PM
  Subject: [BlindHandyMan] need help with another water problem



  >When I moved in my current house I noticed dampness on the back wall 
  >of the garage. Later I realized when it rained really hard or 
  >persistently, water was standing behind the garage and moistening 
  >the wall. Well later, I had a 20 by 20 sun room build behind the 
  >garage. I assumed, wrongly, this would alleviate my water problem. 
  >Now when it rains hard or persistently, I get water in the end of 
  >the room at precisely the same location of the previous problem, 
  >only now it is along the rear of the room as well as along the side 
  >adjacent. So far I have not finished that room so the problem is not 
  >as bad as it could be.

  I blame this problem on the fact that because just behind my new room 
  is a rather steep grade of about 5 or 6 feet high. Now what I would 
  like to do is channel this water about 10 or 15 feet to the other 
  side of my driveway ware there is a ditch which would take the 
  offending water to the street drain.

  I considered digging a trench behind the room at the end ware the 
  problem is and over to the ditch at the other side of my drive, 
  placing some of the 4" perforated plastic drain pipe in this 
  ditch. Below is a bit of text I took from a guide to get rid of 
  standing water in a yard. Do you think this approach will work for my 
  situation and do you think I could allow vehicles to drive over this 
  berried pipe with out damage to the pipe?

  Getting rid of standing water in your yard.

  Firstbuy some 4" perforated plastic drain pipe. The best kind
  for this purpose is the flexible kind that comes in 100'
  rolls. This type of drain pipe has small slits all around the
  pipe. These slits allow water to enter the pipe so it can be
  carried away.

  Just dig a trench from the center of the low area you are
  trying to drain, to the point that you intend to drain it to.
  Using a simple line level you can set up a string over top of
  the trench to make sure that your pipe runs down hill all the
  way. A line level is a very small level that is designed to
  attach to a string. Any hardware stores sells them for just a
  couple of dollars. Set the string up so it is level, then
  measure from the string to the bottom of your trench to make
  sure you have constant fall. You should have 6" fall for every
  100' of pipe.

  The highest point is going to be the area that you are trying
  to drain, so you only want your pipe deep enough at this point
  so it can be covered with soil. Once the trench is dug just
  lay the pipe in. At the highest end of the pipe you'll need to
  insert a strainer into the end of the pipe to keep soil from
  entering the pipe.

  Cover the pipe with some washed stone, and then backfill the
  trench with soil. The washed stone creates a void around the
  pipe so that the water can find it's way into the pipe. Washed
  stone is usually inexpensive stone that has been washed so it
  is clean and free of mud. The only part of the pipe that needs
  to be exposed is the low end, where the water exits the pipe.
  Do not put a strainer in that end.

  Thanks.

  Kevin Doucet
  [EMAIL PROTECTED]

  confuse as says

  Blind man with unmarked forehead has large belly!



   

[Non-text portions of this message have been removed]

Reply via email to