Hello Roger, Here is an idea that will make a portable see saw.
How to make a see saw needed items: 4 8 foot 4 by 4 3 8 foot 2 by 10 2 8 foot 2 by 4 1 8 foot 1/2 by 4 1 9 foot 2 inch galvanized pipe 1 12 inch 2 1/4 inch galvanized pipe 4 2 1/4 galvanized u bolts 2 2 1/2 galvanized u bolts 1 pound 2 1/2 galvanized robert head screws Take the 1 foot galvanized pipe and the 2 1/2 galvanized u bolts and bolt the pipe in the middle of one of the 2 by 10's. cut one of the 4 by 4's to the height of the see saw ( maybe 2 foot ) brace the 2 foot 4 by 4 in the middle of the other two 2 by 10 boards. run one of the remaining 4 by 4 as a cross member between the upright 2 foot 4 by 4 slide the 9 foot pipe through the 2 / 1/2 pipe mounted in the middle of the 2 by 10 cut the 1/2 by 4 in half ( 2 4 foot sections ) lay the 1/2 by 4 on the 4 by 4 cross member make sure that the outside edge is flush place the 9 foot pipe with the " see saw " in the middle of the cross member. the 1/2 by 4 should keep the " see saw " up high enough to rock back and forth or up and down mount the 9 foot pipe onto the cross member with the remaining u bolts use one of the remaining 4 by 4 pieces as a brace in the middle of the cross member. take your time try to picture the event have fun and be careful ----- Original Message ----- From: Rodger Hood To: blindhandy...@yahoogroups dot com Sent: Tuesday, May 12, 2009 12:31 PM Subject: [BlindHandyMan] Voice on the Go generated email %3 Rodger Hood sent you this voice-to-text generated email using Voice on the Go. Voice on the Go translates voice to text. To listen, click on the voice message link or open the attachment. Good morning everyone. I have been assigned by my granddaughters, age 6,7,and 10. To build a seesaw. How do you go about building a seesaw? Thanks very alot. http://vemail.voiceonthego.com:8080/enterprise/Recordings/R1242145548518.wav [Non-text portions of this message have been removed] [Non-text portions of this message have been removed]
