Aloha everyone, Two tiny questions. Not sure what some of these things are called, so bare with me. I removed the tank and took all of the guts out of it. I scrubbed it down with bleach, rinsed it until I was sure it was done, wiped it off with clean lintless rags, and let it bake in the sun for a bit to make sure it was really dry.
I managed to get all of the rebuild kit into place, but now I have two questions. When I removed the tank from the stool, there was a flat gasket between the bottom of the tank and the top of the stool. It is shaped like the letter U. It is about half an inch wide. The open part of the U was facing the seat. outside of the U were two round flat washer looking things, but they were part of the main gasket. They matched the holes that the bolts go through to attach the tank and the stool. This rebuild kit doesn't have anything in the box that looks like that. Do I need to get one? If so, what do you call it? Second question: The round pipe looking thing that the little hose attaches to inside the tank that the water flows through, for the water to go into the tank is too tall. I read somewhere that it should be one inch lower than the little ring on the part where the float cup is. Should I use a hacksaw to shorten it? Hope I haven't confused you.. Thanks bunches, Betsy . End of Message ****************************************************************** Dolphin Press can provide all of your print-to-Braille, large print and audio cassette solutions so you can provide effective, meaningful communication. Quick Response; ACCURATE TRANSLATION; REASONABLE RATES. Call toll free: 888-868-4717, or e-mail, [email protected], http://www.dolphinpress.biz. ******************************************************************
