Dan, This sounds like a neat idea Dale had but also sounds like a lot more work and tinkering. Probably if time is not a premium I would consider but that has to take a lot of time doing all the setup & dadoing. Personally I'd go with the precut stringer or your idea of a two by four and then nail or screw to that. I don't see where the dadoing thing would be stronger. Granted it may look better or more professional but again it is the trade off with time. Just my two cents
al -----Original Message----- From: [email protected] [mailto:[email protected]]on Behalf Of Dan Rossi Sent: Monday, May 24, 2010 11:45 AM To: [email protected] Subject: Re: [BlindHandyMan] Building stairs. Dale, Interesting. I hadn't thought about dadoing the treads and risers into the stringers. I was just going to screw pieces of 2X4 to the stringers and screw or nail the treads down to the 2X4s. How deep would you dado? Quarter inch? Half inch? I wasn't certain about the wedging. Do you mean you cut the dado just a bit longer than the length of the tread and then wedge behind the tread? So, if you are doing blind dados, and using a three quarter straight bit, don't you end up with funky ends to the dado that you have to clean up? How do you physically attach the treads to the stringers? Or don't you? -- Blue skies. Dan Rossi Carnegie Mellon University. E-Mail: [email protected] Tel: (412) 268-9081 [Non-text portions of this message have been removed]
