Dale, Thanks for your suggestions. I did check on some of the screws I did get out using your suggestions and they are in fact Phillips. Hopefully I'll get most of them out but thanks to you and others on the list for your suggestions
Al -----Original Message----- From: [email protected] [mailto:[email protected]]on Behalf Of Dale Leavens Sent: Wednesday, June 23, 2010 9:43 PM To: [email protected] Subject: Re: [BlindHandyMan] Deck board screws You will be very unlucky indeed if you hit any of the original screw shafts with your new screw. You might check too if the original screws are in fact Philips screws. they may be the square drive and superior Robertson screws which is why your Philips driver is stripping them. Generally they get stripped going in but are fine on the way out if you bear firmly and straight down on them. You might also want a new driver with sharper and fresh tines to better grab the old screws. ----- Original Message ----- From: Alan & Terrie Robbins To: [email protected] Sent: Wednesday, June 23, 2010 8:04 PM Subject: RE: [BlindHandyMan] Deck board screws Eric, Your idea is one I did think of, however, the only concern I have is if they end up flush with the joist I am going to have to be very careful the new hole does not get drilled where the cut off screw is. Al -----Original Message----- From: [email protected] [mailto:[email protected]]on Behalf Of Eric Sent: Wednesday, June 23, 2010 7:53 PM To: [email protected] Subject: Re: [BlindHandyMan] Deck board screws The only good way would be to use a saws all to cut the screws off at the joists. Two screws per board at every joist is fine, just sink it a little. Eric ----- Original Message ----- From: Alan & Terrie Robbins To: Blindhandyman Sent: Wednesday, June 23, 2010 6:46 PM Subject: [BlindHandyMan] Deck board screws Looking for some opinion before I replace the surface boards on our 12 by 16 exterior deck. I will be using the pressure treated premium decking which they refer to as a five quarter by six. The actual finished width is about 5 and a half inches. Anyway after I get done removing the old, which I may say is no small task as many of the Phillips screws are counter sunk and of course stripped. So one question is maybe somebody has some novel ideas on removing them that I have not thought of? All ideas welcome. My question on the new boards is to minimize cupping over the years do you think its over kill to use 3 deck screws per joist rather than the way it is now with 2? thanks Al [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed]
