Hi, all A very odd thing happened while recalibrating for a second time. I'd left the machine to its own devices as instructed both on this list and by the manual, but when I checked on its progress after some hours, the unit had completely frozen (apart from a strange clicking sound which I think was made by the display which read "I'm talking until my") and I was forced to reset to unfreeze it. Naturally, I had turned speech off when the process started some nine hours before, but when the thing was locked, speech had somehow been turned off!
after the reset, I entered support information mode and pressed C and got a figure of 888. Then I pres D and got 998. I then pressed E (to see what would happen) and it went on about voltage being critical. However, my gauge told me it was 100%. However, that can't have been right, as I've restarted the calibration process and it claims it's doing an initial charge. I'd really appreciate some expert thoughts on this one. Of course, I may have caused the whole problem by halting the process after only one cycle when I tried recalibrating for the first time last week. I hadn't known (even after reading the manual) that the unit might need several cycles until calibration is completed until Jonathan's mail of about 24 hours ago. Thanks in advance of any help. It would certainly be appreciated. I don't want to have to send the thing in as although I have an embosser now, I'm trying to hold out plugging it in at home as work is supposed to be getting me a fully-equipped office on their premises, and I don't really have the room here now. TIA Kylee
