Instructions for Using the Braille note with the Braille Blazer
Serial Port
Configure the Braille Blazer Serial Port:
1. Turn on Braille Blazer (BZ). For purposes of this article,
orient the BZ so that the carrying handle is away from you,
the single rocker switch is on the left, top surface of the
BZ and the row of three buttons is on the right side of the
top surface of the unit.
2. Simultaneously press all three buttons on the top surface of
the BZ. It will say Configuration Speech Config
3. Press the center button three times. It will say Serial
Config.
4. Press the button nearest you. It will say BAUD Rate ####
active. where #### is the BAUD Rate setting. Continue to
press it until it says nine thousand six hundred"
5. Press the middle button. It will say Bits per character #
Active
6. Press the button nearest you until it says 8
7. Press the Middle button. It will say Stop Bits # active
8. Press the button nearest you until it says 1.
9. Press the middle button. It will say parity ??? active It
should say None. If not
10. Press the button nearest you until it does say None.
11. Press the middle button. It should say Handshake Software
Active If not
12. Press the button nearest you until it does say Software.
13. Press the middle button 2 times. It will say Exit.
At this point the BZ ins configured. Now you will need to tell
it that you want it to receive information from the serial port.
1. Press all three buttons again. It will say configuration
Speech Config.
2. Press the middle button once. It will say Printer config.
3. Press the button nearest you once. It will say Port ???
Continue to press it until it says
"serial".
4. Press all three keys twice. It should say "Exit"
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
