Hi, Don. I do use a serial cable. So, I guess we will see how it goes.
At 3/11/2004, you wrote:
Hi Paul,
I didn't have to change anything in after upgrading to keysoft 5.1 except
that I did have to reestablish my partnership in activesync and send the
proper
parameters again to the bn in order to use activesync via the ethernet
card. I just deleted my previous partnership from within activesync and
started over.
Everything went smoothly and no problem. The partnership re-establishment
is something that usually happens whenever you do a hard reset of the bn
anyway, so I wasn't surprised.
If you haven't been using a partnership in the first place and are
connecting via serial port, you shouldn't have to do a thing to activesync
after the 5.1
upgrade.
Don
On Thu, 11 Mar 2004 15:05:09 -0800, Paul Henrichsen wrote:
Hi. Is there anything I need to set up in the new active sync so that it
works properly? I assume it kept my old settings, but I just wanted to check.
Thanks.
Paul Henrichsen
<[EMAIL PROTECTED]>
<home.pacbell.net/paulh52>
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.pulsedata.com/mailman/listinfo/braillenote
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.pulsedata.com/mailman/listinfo/braillenote
Paul Henrichsen
<[EMAIL PROTECTED]>
<home.pacbell.net/paulh52>
