Tony, Check the high limit switch on top of the brew boiler. It has a tiny reset button on it. ----- Original Message ----- From: "TonyNJ" <[email protected]> To: "Brewtus" <[email protected]> Sent: Friday, October 02, 2009 3:16 PM Subject: Brewtus II seems to not be heating correctly..
> > Hi Brewtus detectives.... another mystery. > > Problem is that the water heater is not heating to the set point of > 95.... > > Trouble shooting clues: > > Steam boiler working fine: steam pressure good, steam wand good, hot > water wand good. > > Water boiler only heats to about 47 degrees. > > Set point of red LED temperature controller is set to 95, small > indicator indicates "ON" all the time.. Water coming out of brew group > is indeed 47 degrees (measured), Brew group itself is about 47 degrees > (by touch... ) > so it seems like the controller thermometer is accurate and indicating > the boiler should heat. > > Large red light to right of brew group lights when it heats the water, > and goes out when it does not: I can hear quiet gurgling during > heating, but then light turns off (and gurgling stops) at about 47 > degrees. noise is normal, temperature is not. > > This happened suddenly, not gradually. coffee this AM was fine (95 > degrees as programmed), this afternoon, it holds at about 45-47. > > Suggestions? > > Thanks in advance. This machine has served us very well for 3 or 4 > years now. > > > --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/brewtus?hl=en -~----------~----~----~----~------~----~------~--~---
