karl, look at your brew boiler limit thermostat on top of the boiler. theres two wires going to it. it has a tiny button on it that is a resettable breaker. push that button and check brewtus again. - Dennis
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Karl Sent: Sunday, February 13, 2011 10:27 AM To: Brewtus Subject: Brew Boiler down Brewtus II has failed. Pump works, water coming out of grouphead is tepid. Steam boiler heats up, I think to full temperature since it makes steam normally. Brew boiler does not heat up. Display goes up to about 31, with some fluctuation. I assume this is caused by the heat of the hot steam boiler warming up the brew boiler. I seem to have connectivity between both wires on the two heating elements. I seem to have connectivity across the steam boiler thermostat but not across the brew boiler thermostat. Can anyone confirm that I should have connectivity across the brew boiler thermostat? I'm not too sharp with this sort of thing, but from the diagrams it looks to me that if you don't have connectivity across the brew boiler thermostat you don't get juice to the brew boiler heating element. Can anyone tell me if it looks like all I need to do is replace the brew boiler thermostat, and, if so, how difficult that is? Karl -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/brewtus?hl=en. -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/brewtus?hl=en.
