Bewtus is up to temperature and running fine. Ran a few sink shots through getting the grinder dialed back up for espresso from press pot and now everything is back to normal.
Can't believe it was such an easy fix. Thanks again! Karl On Feb 13, 1:09 pm, Karl <[email protected]> wrote: > Just pushed it and the display is up to 50 already! > > I feel kind of stupid, since my Silvia has a similar reset which I've > used. Didn't know Brewtus thermostats had them. Looks like I've been > reduced to using the press pot for a month, for no reason, while I > pondered all this! > > Thanks so much, > Karl > > On Feb 13, 12:51 pm, "Dennis Keating" <[email protected]> > wrote: > > > karl, look at your brew boiler limit thermostat on top of the boiler. > > theres two wires going to it. it has a tiny button on it that is a > > resettable breaker. push that button and check brewtus again. - Dennis > > > -----Original Message----- > > From: [email protected] [mailto:[email protected]] On Behalf > > > Of Karl > > Sent: Sunday, February 13, 2011 10:27 AM > > To: Brewtus > > Subject: Brew Boiler down > > > Brewtus II has failed. > > > Pump works, water coming out of grouphead is tepid. > > > Steam boiler heats up, I think to full temperature since it makes steam > > normally. Brew boiler does not heat up. Display goes up to about 31, with > > some fluctuation. I assume this is caused by the heat of the hot steam > > boiler warming up the brew boiler. > > > I seem to have connectivity between both wires on the two heating elements. > > I seem to have connectivity across the steam boiler thermostat but not > > across the brew boiler thermostat. > > > Can anyone confirm that I should have connectivity across the brew boiler > > thermostat? I'm not too sharp with this sort of thing, but from the diagrams > > it looks to me that if you don't have connectivity across the brew boiler > > thermostat you don't get juice to the brew boiler heating element. > > > Can anyone tell me if it looks like all I need to do is replace the brew > > boiler thermostat, and, if so, how difficult that is? > > > Karl > > > -- > > You received this message because you are subscribed to the Google Groups > > "Brewtus" group. > > To post to this group, send email to [email protected]. > > To unsubscribe from this group, send email to > > [email protected]. > > For more options, visit this group > > athttp://groups.google.com/group/brewtus?hl=en. -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/brewtus?hl=en.
