Hey Pete-- It may take a wrench to get it off, but when you put it back on, just go finger-tight. I use one of those rubber jar lid grippers. bmc On Apr 19, 2011, at 7:04 AM, [email protected] wrote:
> Interesting - thanks for the replies Todd and Ben. I will take a look > at it when I get home from work tonight. I assume it is a pretty > simple procedure to remove the tip - a small adjustable wrench would > seem to do the trick. Will let you both know how I make out. > > Pete > > > > On Apr 19, 7:59 am, Benjamin McCafferty <[email protected]> wrote: >> Hey Pete, >> >> I have the no-burn wand and it is the same as yours. I just always assumed >> that it was one of those things where it heats up more slowly than an >> unlined wand. But mine has always gotten hot at the end also. Compared to >> a "normal" steam wand, however, it is much easier to handle. I've left skin >> on a normal wand! Seeing Todd's reply, I can also say that my teflon tube >> is well seated into the tip. >> >> bmc >> >> On Apr 19, 2011, at 6:32 AM, [email protected] wrote: >> >> >> >>> Yet another question from the newbie - I was wondering anyone else has >>> experienced their no burn steam wand heating up after a couple of >>> uses. I noticed this morning that the wand was quite hot to the touch >>> after making two back to back lattes. The wand remains cool while >>> idling, and after running for 35 to 40 sec. Anything over this seems >>> to increase the heat. There are no leaks (either steam or water) I'm >>> noticing from the wand after steaming, so I don't think a seal has >>> blown. Any ideas? or is this normal operating behavior..... >> >>> Thanks! Pete >> >>> -- >>> You received this message because you are subscribed to the Google Groups >>> "Brewtus" group. >>> To post to this group, send email to [email protected]. >>> To unsubscribe from this group, send email to >>> [email protected]. >>> For more options, visit this group >>> athttp://groups.google.com/group/brewtus?hl=en. > > -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]. > For more options, visit this group at > http://groups.google.com/group/brewtus?hl=en. > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/brewtus?hl=en.
