Ben sent me this when I changed mine and it works great.Good luck. Herman On Tue, May 10, 2016 at 11:48 AM, Eric S <[email protected]> wrote:
> Hi, > I recently purchased on older version Brewtus used and needing repair. > > The word was they had a new control board put in about 6 months ago. It > worked fine, until the reservoir was overfilled. He cleaned up the mess, > went on vacation for a week, and when he came back no heat. > > > Sent it back to the repair tech, that determined that at least one of the > heaters needed to be replaced. > > So now I am waiting for new Heating element from WLL, I am trying to check > the wiring and everything to see if I can figure out what caused the short. > > > > <https://lh3.googleusercontent.com/-emSMabmw3xE/VzICnRZOJ9I/AAAAAAAAAEw/HlEIfOVL_Jc9MDSnnVWebAN4lxsSYBhKQCLcB/s1600/IMG_0814.JPG> > With all that out of the way. I was looking at the wiring this morning > and I noticed that someone had numbered the terminals going into the > control board, but they don't match the actual numbers on the control > board. Does anyone have a wiring diagram to show where the wires are > supposed to go. > > Thanks > > > -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at https://groups.google.com/group/brewtus. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
