thanks. On Tuesday, May 10, 2016 at 10:48:59 AM UTC-5, Eric S wrote: > > Hi, > I recently purchased on older version Brewtus used and needing repair. > > The word was they had a new control board put in about 6 months ago. It > worked fine, until the reservoir was overfilled. He cleaned up the mess, > went on vacation for a week, and when he came back no heat. > > > Sent it back to the repair tech, that determined that at least one of the > heaters needed to be replaced. > > So now I am waiting for new Heating element from WLL, I am trying to check > the wiring and everything to see if I can figure out what caused the short. > > > > <https://lh3.googleusercontent.com/-emSMabmw3xE/VzICnRZOJ9I/AAAAAAAAAEw/HlEIfOVL_Jc9MDSnnVWebAN4lxsSYBhKQCLcB/s1600/IMG_0814.JPG> > With all that out of the way. I was looking at the wiring this morning > and I noticed that someone had numbered the terminals going into the > control board, but they don't match the actual numbers on the control > board. Does anyone have a wiring diagram to show where the wires are > supposed to go. > > Thanks > > >
-- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
