minor update: I just did the pump check <https://www.youtube.com/watch?v=kEl-uNOC1P4>, and with the blind disc in holding pressure, I'm only getting a very slow drip from the return tube back to the water tank - not the 1 oz-ish in 12 seconds. This most likely suggests the pump is on its way out right?
The other difference I can see is my OPV is set to about 12 bar, so could lowering it cause it to behave "closer" to normal behaviour? Whats unfortunate is I see during previous servicing, the OPV wasn't placed in a way where the set screw is adjustable from the front of the machine through the hole. So I may have to open it up to experiment further. On Tuesday, 19 November 2019 21:15:07 UTC-5, Johnty Wang wrote: > > Greetings! New(ish) owner of a used Brewtus III here. I think I'm facing > the OPV/pump issue that others have experienced: basically with the blind > basket it can reach and hold pressure at 10 bars, but when actually brewing > a shot, *sometimes* I the pressure drops from 10 bars to around 6, and > then back and forth again throughout the shot. > > I see that WLL has the pump/OPV/Deairator > <https://www.wholelattelove.com/products/expobar-vibration-pump-kit>available. > > Can someone confirm that it's the same one for the III? Also, given the > above symptoms, it's likely either the pump, OPV, or both that needs > replacement, correct? > > Thanks! > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/brewtus/8415efed-fb1e-4fd5-b371-8ccf4902821f%40googlegroups.com.
