Thank you Brian and Ira. I had a similar thoughts regarding the location after comparing it to the diagram. I double checked the balancing circuit with adjusting screw and the spring diameter is too large. I do have other pieces apart but can’t seem to find any place were it belongs.
> On Dec 29, 2020, at 20:39, Brian <[email protected]> wrote: > According to the exploded parts diagram there are no additional springs > there. If you have other parts disassembled at the same time, is it possible > it came from somewhere else? Otherwise I’d have to agree with Ira, that it > must be from the balancing circuit in the pump head that regulates maximum > pressure. > > Though I have a vibratory pump so I couldn’t say for sure.Here’s a link to > the parts diagram, Incase it’s helpful with the rest of the job, good luck! > On Tuesday, December 29, 2020 at 1:38:58 AM UTC-5 Mario G wrote: >> I forgot to add, the spring measures ~19mm long by ~14mm diameter. >> >> Thanks again, >> Mario >> >>> On Dec 28, 2020, at 22:32, Mario G <[email protected]> wrote: >>> Hello Everyone, >> >>> >>> I purchased a used Brewtus III-R about 6 months ago and noticed signs of >>> excessive scale. I was encouraged by what I see some have done here in this >>> Google group, so I am in the middle of a full teardown for descaling and >>> maintenance. >>> >>> I was sure I had awesome documentation pictures and every diagram I could >>> ever need, but I am having some trouble while assembling the pump valving. >>> I cannot figure out where the spring circled in this picture belongs. Under >>> the inlet or outlet fitting? Inside the retention valve? >>> >>> Any help would be outstanding! >>> >>> Thanks, >>> Mario >> >>> -- >>> You received this message because you are subscribed to a topic in the >>> Google Groups "Brewtus" group. >>> To unsubscribe from this topic, visit >>> https://groups.google.com/d/topic/brewtus/gnEYutSekac/unsubscribe. >>> To unsubscribe from this group and all its topics, send an email to >>> [email protected]. >>> To view this discussion on the web visit >>> https://groups.google.com/d/msgid/brewtus/141897fa-d84c-4cb2-b742-d21d8300fc42n%40googlegroups.com. > > -- > You received this message because you are subscribed to a topic in the Google > Groups "Brewtus" group. > To unsubscribe from this topic, visit > https://groups.google.com/d/topic/brewtus/gnEYutSekac/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/brewtus/205a478a-97bd-4658-a63a-4bf3f39cffe9n%40googlegroups.com. -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/brewtus/9B06CEF8-BEE2-4A9D-8DA6-108E2B7AC946%40gmail.com.
