https://youtu.be/UIiLeRdVWAU?si=az_lw9PJyECbq9nu

This is an instructional video fro Whole Latte Love. It will pin point
every component, this should help you out.  I have had catastrophic failure
of PID. Complete meltdown. When I called Italy they informed me that my
machine was designed for EU( 220v@ 10 amps) not (120v@ 20 amps). I upgraded
all wiring and have not had a single issue for about 4 years. I have had
not luck with the automatic timers due to amp draw. I hope this helps.

On Sun, Feb 18, 2024 at 8:22 AM 'Ben McCafferty' via Brewtus <
[email protected]> wrote:

> Hey all, hope all are good. Still lurking, though my B2 has been retired
> for quite a while now!
>
> Hoping someone might have insight—the ECM is an E61 machine, largely
> similar to the Brewtus. It has a green light to indicate power (like the
> lighted switch on the Brewtus), and a separate orange light when heating.
> It also indicates heating with a pulsing dot on the control board/display.
> Like the Brewtus, it has two boilers and can run on a 110V circuit by
> prioritizing one at a time.
>
> The machine is on a timer, so normally kicks on early and is up to temp
> when I get up. The past two mornings, the machine has had a green light
> (i.e. it has power), but no orange light and the machine is cold. If I
> power-cycle, i.e. turn it off and back on with its own switch, it heats
> normally. Something is failing, just not sure what.
>
> For reference, the one time I’ve had a boiler element go bad, it would
> heat partially and then trip the GFI, much like the Brewtus would. So I
> don’t think it’s that.  Maybe the PID controller going bad?  Other thoughts?
>
> Thanks as ever,
> Ben
>
> --
> You received this message because you are subscribed to the Google Groups
> "Brewtus" group.
> To unsubscribe from this group and stop receiving emails from it, send an
> email to [email protected].
> To view this discussion on the web visit
> https://groups.google.com/d/msgid/brewtus/FDFB3CBD-692D-4D31-AF28-7D8BBC6DFE10%40me.com
> .
>


-- 
"Pitcher"
Stephen Pitcher
[email protected]
225-408-9041

-- 
You received this message because you are subscribed to the Google Groups 
"Brewtus" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To view this discussion on the web visit 
https://groups.google.com/d/msgid/brewtus/CACn%2BS8HFVkw2xF1CUR14j7_bWqbrRVRy0xVm4uiSFPLbws-Zug%40mail.gmail.com.

Reply via email to